Remote Control Air Compressor, Special Remote Control

Power Direct Ouput Remote Controller for Air Compressor

Question from customer:

I have an air compressor that sits about 100’ away, and want to open an air valve to actuate the blown horns that I have installed in the center of the arena. Do you have a setup that I can purchase or any suggestion?

Answer

We recommend the model of DC voltage output remote control kit (S1X-DC12&C-2). It is voltage output receiver so you can connect a 12V battery to this receiver and connect your air valve to the output of this receiver, the air compressor can get power through receiver. Then you can use the remote to control them.

remote control

The remote control operates in toggle, momentary and latched mode (set the mode as you like freely). We suggest setting latched mode because the receiver pairs with 2-button transmitter. One button controls “On”, another button controls “Off”.

Wire air compressor to the receiver as the following picture shown. This receiver is designed with voltage direct output configuration. You can wire your air compressor to terminals A&B of the receiver and then supply 12V power to receiver.

1_09

Operation:

Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.

Control mode Latched: Press -> On, other relays Off; Press another button -> Off.

Press button 1: open the air valve, turn on the air compressor.

Press button 2: close the air valve, turn off the air compressor.