ac 220 – Remote Control Everything

There are various types of pool rolling shutters such as winter shutters, solar shutters, and safety shutters. All kinds of shutter can prevent leaves or other things falling in pool. Winter pool shutter can keep water warm when winter comes. Safety pool shutter can prevent accidental drowning, especially for children. No matter any purposes for pool shutter, it is most important for pool shutter to be convenient to you. So maybe you really need to your retrofit your pool rolling shutter instead of manual control. You can remote control your existing shutter motor to realize open and closed.

You may wonder how to do this. Please see the following.

You will see the 2 channel time-delay remote control kit (S2DA-AC220+C-4), ac motor or other gadgets.

1 x 2 channel delay time adjustable receiver (S2DA-AC220)

1 x 4-button transmitter (C-4)

AC power supply

Wire

You can see the wiring diagram. AC motor is supposed to connect to common terminal B. Live wire is connected to normally open terminals C. And neutral wire is connected to AC motor.

Here comes to operation

At first, we set delay time 8 seconds for relay 1 and 10 seconds for relay 2. Then switch on power.

Press button 1, the motor rotates continuously in the positive direction.

If we want to interrupt the rotation, we can press button 3, the motor stops rotating immediately.

Press button 2, motor rotates continuously in the reverse direction.

If we want to interrupt the reverse rotation, press button 4, the motor stops right away.

Time Delay Mode

Press button 1, the motor positive rotation will last 8 seconds which is set in advance, then stops rotating.

Press button 2, the motor reverse rotation will last 10 seconds which is preset, then stops rotating.

Video:

In a switch where the contacts remain in one state unless actuated, the contacts can either be normally open (abbreviated “n.o.” or “no“) until closed by operation of the switch, or normally closed (“n.c.” or “nc“) and opened by the switch action. Our remote receiver can be grouped into two types according to its current output modes. They are normally open/closed switch connection or current direct output connection (Controlled device can get power from powered receiver directly).

Recently, one customer sent a picture of “Normally Open/Closed Receiver Connecting to an AC Lamp” to us to ask whether it is correct or not.

Unfortunately, it is a wrong wiring. Please see a red cross to the lamp wiring from the following picture. This red cross points out the wrong wiring. AC lamp should not wire to the normally open terminals of receiver because there is no current through them which are only equivalent to a switch.

The correct wiring is as follow. This is the 1 channel normally open/ closed ac receiver (S1U-AC220) wiring. AC lamp is connected to normally open terminals B&C. And add a wire between terminals B&N and another wire to terminals C&L. At last, wire a plug to terminals L&N. Then, we finish the wiring.

Tag: ac 220

2 Channel Time-Delay Remote Controller Controls Pool Rolling Shutter Open and Close

Normally Open /Closed Wiring Method