wireless remote control RF DC motor

1 channel wireless controller remote control RF DC motor positive or reversal rotates

Question from customer:

My plan is to be able to remotely control an RC motor forward and backward wirelessly with the remote. I was thinking one receiver and one remote, but which products would I be able to do this with.

Answer:

This is the system of wireless remote control RF DC motor which we recommend you. It is model: S1FU-DC09/12/24 & C-3-2. The receiver (S1FU-DC09/12/24) is 1 channel and working voltage is AC 110~240V or DC 0~28V. The transmitter’s (C-3-2) remote control distance is 100m/300ft (theoretically). The wireless system can remote control motors of rolling blinds / doors, awnings, winches, cranes or other home electrical devices and small industrial equipments. You just need to connect a motor to the receiver, then you can remote control the motor rotates in the positive or reversal direction by using wireless transmitter.

1_02  001

Here is the circuit diagram of receiver. You can connect one motor to terminal B of relay 1 and relay 2. Then supply power to receiver. You use wireless transmitter to remote control motor rotate.

1_09

There are three control modes for the wireless remote control system: toggle, momentary, latched. You can set any one of three modes as the operation:

When you only connect jumper-2, it is toggle mode.

Press button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Press button ▲ again: Terminal B of relay 1 and relay 2 no output, motor stops
Press button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Press button ▼ again: Terminal B of relay 1 and relay 2 no output, motor stops

When you only connect jumper-1, it is momentary mode.

Press and hold button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Release button ▲: Terminal B of relay 1 and relay 2 no output, motor stops
Press and hold button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Release button ▼: Terminal B of relay 1 and relay 2 no output, motor stops

When you don’t connect jumper-1 and jumper-2, it is latched mode.

Press button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Press button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Press button ■: Terminal B of relay 1 and relay 2 no output, motor stops

 1_06

Finally you can also enter into the website and search the wireless remote control system as following:

 

Model: 0020202 (S1FU-DC09/12/24 & C-3-2)

 

 

Website:

http://www.carymart.com/

 

RF

http://www.rfcontrolsystem.com/