Question from customer:
My plan is to be able to remotely control an RC motor forward and backward wirelessly with the remote. I was thinking one receiver and one remote, but which products would I be able to do this with.
Answer:
This is the system of wireless remote control RF DC motor which we recommend you. It is model: S1FU-DC09/12/24 & C-3-2. The receiver (S1FU-DC09/12/24) is 1 channel and working voltage is AC 110~240V or DC 0~28V. The transmitter’s (C-3-2) remote control distance is 100m/300ft (theoretically). The wireless system can remote control motors of rolling blinds / doors, awnings, winches, cranes or other home electrical devices and small industrial equipments. You just need to connect a motor to the receiver, then you can remote control the motor rotates in the positive or reversal direction by using wireless transmitter.
Here is the circuit diagram of receiver. You can connect one motor to terminal B of relay 1 and relay 2. Then supply power to receiver. You use wireless transmitter to remote control motor rotate.
There are three control modes for the wireless remote control system: toggle, momentary, latched. You can set any one of three modes as the operation:
When you only connect jumper-2, it is toggle mode.
Press button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Press button ▲ again: Terminal B of relay 1 and relay 2 no output, motor stops
Press button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Press button ▼ again: Terminal B of relay 1 and relay 2 no output, motor stops
When you only connect jumper-1, it is momentary mode.
Press and hold button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Release button ▲: Terminal B of relay 1 and relay 2 no output, motor stops
Press and hold button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Release button ▼: Terminal B of relay 1 and relay 2 no output, motor stops
When you don’t connect jumper-1 and jumper-2, it is latched mode.
Press button ▲: Terminal B of relay 1 and relay 2 output + DC 12V (1: +, 2: -), motor rotates in the positive direction.
Press button ▼: Terminal B of relay 1 and relay 2 output - DC 12V (1: -, 2: +), motor rotates in the reversal direction.
Press button ■: Terminal B of relay 1 and relay 2 no output, motor stops
Finally you can also enter into the website and search the wireless remote control system as following:
Model: 0020202 (S1FU-DC09/12/24 & C-3-2)
Website:
RF
http://www.rfcontrolsystem.com/