Tri-mode Vibrator&Beeper Kit Works with Wireless Remote Button

Sometimes, we need alerting devices or reminders to remind us of doing something. We can use audible signaling device like beeper, buzzer. We can use vibrating alerts when a user cannot hear the ring tone (a noisy environment or through hearing loss) or wants a more careful notification. Now, our 433MHz tri-mode vibrator& beeper kit is made up of built-in vibrator and buzzer which can pair our 1000m 999-channel numeric keypad wireless transmitter. When they are paired up, wireless button can remote control this vibrator& beeper kit.

calling-button&vibrator_1

The wireless transmitter can send 999 different wireless RF signals by pressing a number from button 1 to 999.

 

Pairing up wireless button and Vibrator& beeper kit

Note 1: Here we only pair button 1 on the transmitter to vibrator& beeper kit just for an example.

1) Press and hold the learning button of the receiver for about 5 seconds, then release the button when LED light is on, the receiver is in the status of Learning. 2) Press button 1 of transmitter within 10 seconds, if LED light of kit flickers twice then off, it means Learning is successful. At the same time, the LED light of transmitter will flicker too. If LED light is off after 10 seconds, it means Learning is failed and the receiver quits the status of Learning. 3) The receiver can learn several remote controls of different codes

1 transmitter (with 999 channels, one channel for one vibrator& beeper kit) can pair up 999 vibrator& beeper kit.

Note 2:

We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all stored codes: Delete all stored codes: Press and hold the button of the vibrator& beeper kit for about 5 seconds until LED light turns on and go on holding till LED light turns off, then release the button, all stored codes have been deleted successfully. At this time, the transmitter cannot control the receiver.

Note 3:

If you want to delete all stored codes, you should first switch off the receiver and switch on again, then you can go on deleting codes.

 

Operation:

•Vibration mode: Press the button 1 of transmitter, then press the “Send” button to transmit this wireless signal. The receiver kit vibrates for 5 seconds.

•Beep mode: Press the button 1 of transmitter, then press the “Send” button to transmit this wireless signal. The receiver kit beeps for 5 seconds.

•Vibration & Beep mode: Press the button 1 of transmitter, then press the “Send” button to transmit this wireless signal. The receiver kit vibrates and beeps together for 5 seconds.

•Changing modes: As long as press the button of receiver, you can switch those three working modes optionally. Such as press the button of receiver, switch to beep mode from vibration mode; press the button of transmitter again, switch to vibration & beep mode; press the button of transmitter again, switch to vibration mode.

Delete wrong digit

•If you press wrong digit before pressing the “Send” button, you can press “Delete” button to delete all numbers you pressed previously.

Leave a Reply