Wireless remote control computer power switch on and off

One of our customers wants a remote controller to switch on his computer. We think this set of controller is favorable for him. It’s the 1-channel rf momentary remote control  This set of remote controller:

picture 1

The wiring processing is very simple.

Step 1,open the computer and find two wires of switch on computer(see the following picture).

picture 2

Step 2, Wires should be connected to B&C terminal of the receiver; The receiver should be connected to the power supply.

picture 3

Step 3, Two wires from B&C terminal of receiver should be soldered to switch wires.

picture4

Step 4, Press button, and turn on the computer.

picture5

Step 5, Press and hold button for 5 seconds then release, turn off the computer.

picture 6

picture7

You can turn on the computer with a handy remote controller when you arrive home as long as you use our rf products.

Online shop: www.carymart.com/

An easy way to control a winch remotely

We usually use winch to help us to hoist heavy stuff to higher place or drop to lower place. For example, farmers always store the grain in the warehouse in every harvest season. But the warehouse sometimes is an attic. They usually have to hoist grain bag to the attic by themselves in the past. Actually, that is energy-consuming working. It is too difficult for aged farmers to hoist those heavy bags of grains now. So they want to know if there is an easier way to hoist grain.

The rf momentary motor remote  controller is strongly recommended here. The major characteristic of this receiver is to make the motor in the winch rotate in positive and reversal direction. That is to say, the rope of winch will be stretched out and drawn back by wireless remote controller. The transmitter is also easy to use.

Here are transmitter and receiver.

1_01

The following is the application circuit of receiver.

1_06

From the wiring picture, the wires from the winch are connected to the receiver. We hook up the bag, pressing and holding button ▲ on transmitter. With the motor of winch working continuously in the “UP” direction, the rope is drawn back and the bag is hoisted; When the bag is lifted to the attic, release button ▲, the motor of winch stops working. After putting away the grains bag, we press and hold button ▼ on transmitter, the motor works continuously in the “DOWN” direction , the rope is stretched out and then it reaches the ground.

S1FM-DC&winch2

 

Online shop: www.carymart.com/

How to control the wall light with the remote controller?

Sometimes, you may get up in the mid-night to drink water or go to the toilet. At that time, it is inconvenient to find the switch of the wall light in dark house. Or when you are watching TV in the living room, you forget to turn off the light in the kitchen. You are not willing to miss that wonderful TV program and to waste energy. So you need a remote controller to control the light. We would like to recommend this AC rf remote controller (S1X-AC220&C-2). This receiver, S1X-AC220 can apply to the appliances with AC 100~240V. The rf signal which is sent out by the transmitter, C-2, can pass the through walls, floors and door. You can turn off the light even though you are far away from it.

1_04

Look at the wiring picture, at first, the zero wire and live wire of power supply should be connected to the input contacts of receiver. Then, the wires from wall light should be connected to the output contacts of receiver.

1_09

And then, the transmitter and receiver should come to be “Latched Mode”. When you press the button 1, transmitter is triggered and then transmits an RF signal “ON” to the receiver. After the receiver receives the signal, output contacts are closed; the wall light is on.

S1X-AC-&light

When you press the button 2, the transmitter is triggered and then transmits an RF signal “OFF” to the receiver. After the receiver receives the signal, output contacts are cut, the wall light is off.

Online shop: www.carymart.com/