Pumping water automatically with remote control system

James starts to manage a farm since this year. He needs to pump water to tank in the water tower for irrigation every day. At the beginning, James installed a water level sensor which is connected a gadget with two indication lights. When red light flashing, it means that the water level is low. He needs to switch on the water pump by hand. When the green light flashing, it means that the water level reaches the high level. Gradually, it is tired of him to run to 1000m away to monitor whether water level in the tank gets low or high and switch on or off the pump motor every day. So James would like something will send signal which can make switch of the motor turn on to pump water automatically. So how can we combine pump motor and water level senor with remote controller? Recently, we promote a latched rf remote control system,With the combination of those two gadgets, using a water level senor to remotely control the water pump motor is no longer a Gordian knot. This is a long distance remote controller kit. Transmitting distance is up to 1000m in open field.

1_01

In addition, the major characteristic of CB-2N is that it has two extended wires, which is wired to the electric device. When two wires are connected, the rf signal ”ON” will be sent out; When two wires are disconnected, the rf signal “OFF” will be sent out. That is easy to operate.

1_09

First, look at the circuit configuration.

Remote Control Wireless Switch & Controllers

Here is the wiring picture. The extended wires on transmitter should be connected to the water level sensor. The red wire from the motor is connected to the C terminal of the receiver and black wire from the motor is connected to the negative electrode of the power supply. The positive wire of the supply power is connected to B terminal and positive electrode of the receiver. The negative electrode of the power supply of power supply and receiver are connected together.

CB-2N&water level sensor

S1L-DC&motor-y1

 

When the water level gets low, it makes the contacts of water sensor are closed; with extended wires of transmitter connection, the transmitter is triggered and transmits an RF signal “ON” to the receiver. The receiver output contacts are closed after received the signal, the pump begins to pump water. When the water gets high, it makes the contacts of water sensor are cut; the transmitter is triggered and transmits an RF signal “OFF” to the receiver. The receiver output contacts are cut after received the signal, the pump stops pumping water.

Online shop: www.carymart.com/

Normally Open RF Long Distance Remote Transmitter Application

We usually install security system to help us to monitor the farm. Use infrared movement sensor and ac lamp to make a simple security system, for instance. It’s easy to wire and operate. But if the infrared movement sensor is installed at the door of the farm for monitoring, and the lamp need to be placed inside the farm for warning intrusion. There is a long distance between each other. So the sensor cannot be wired to the lamp directly. They need a wireless signal to work together at this time.

The long distance rf remote transmitter CB-2N is strongly recommended here. It has two extended wires. With the connection and disconnection of two wires, the rf remote transmitter can send out an rf wireless signal “ON” and “OFF”. It pairs with rf receiver S1PX-AC220-ANT2, which has long range with external magnetic antenna. Transmitting distance of this transmitter & receiver set is up to 2000m in open field.

As seen in the picture, two wires on transmitter should be connected the contacts of the infrared movement sensor. The output contacts of receiver should be connected to the ac lamp.

When someone breaks into the farm, the contacts of sensor are closed; transmitter is triggered and then transmits an rf wireless signal “ON” to the receiver. After the receiver receives the signal, output contacts are closed; the lamp turns on to warn the emergency.

When someone goes out of the farm, the contacts of sensor are cut; transmitter is triggered and then transmits an RF signal “OFF” to the receiver. After the receiver receives the signal, output contacts are cut, the lamp turns off.

Online shop: www.carymart.com/