2000m 9V Actuated Toggle Mode Remote Controller Works at a Port

Overview:

I am looking for a RF Remote Control covers a distance of 1000-2000 meters for one port only, and output Relay Minimum with current 3 amps and working on the 9-volt battery.

small-port

Solution:

We recommend This 1 channel dc rf remote control system (S1T-DC09-ANT2+CB-1), which operates in 6V/9V/12V/24V. 12V is the standard voltage. 9V is also available if you need. Any device with voltage of AC110~240V or DC0~28V can be connected to that controller. It is great for hard to reach lights or other DC/AC electrical devices, remote distance is up to 2000m. Applications include light remote control, electric gate remote control, electric window / blind remote control, etc. Then maximum current output is 10 amps and it can work on the 9-volt battery. Transmitter distance is 2000m in the open field.

1

It is the normally open and closed contact, so your device at port is supposed to be wired to normally open contact. You can only wire one device on that controller because it has only one relay (one channel).

1_06

After wiring, the device at port should be added additional power. Turn on the controller.

Press button: Turn on relay, turn on device (connect B and C, disconnect A and B)

Press button again: Turn off relay, turn off device (disconnect B and C, connect A and B)

Remote Control 4 LED Light Strips

Question from customer:

I am looking remote controller to control 4 LED light strips. Each of LED lights should be supported a 9V battery and remote controller should control over them individually wirelessly. I was wondering whether your 9V 4 channel wireless relays are favorable for me, basically, I am looking for a way to wirelessly control 4 led lights that draw very little power.

Answer:

We recommend 9V 4 channel multi-mode remote control module  to you (S4C-DC09 with C-4). This 4CH RF wireless remote control switch operates in toggle, momentary, latched and toggle + momentary control mode (set the mode as you like freely). You can use it to complete four operations at the same time. For example, turn the light on, open the door or control other dc/ac electrical devices in the meantime. It is applied for light remote control, motor remote control, garage door remote control, gate remote control, etc. The remote control distance is 100m (300ft).

As your requirement, you may set “Toggle mode” that means each led light strip will be controlled on and off by one button. They work individually and wirelessly. No interferences among them.

 

 

The following is the wiring diagram. We use four colors to distinguish four LED light strips. Each led light strips’ negative terminal should be connected to the receiver’s negative terminal. Each positive terminal of led light strips is supposed to connect to receiver normally open terminal C. Connect terminals B of receiver to receiver’s positive terminal with wires. At last, switch on the power.

 

 

Setting control mode Toggle: Only connect Jumper-2.

Press button 1, warm white color led light strip is on.

Press button 2, the green led light strip is on.

Press button 3, the red led light strip is on.

Press button 4, the white color led light strip is on.

Press button 1 again, the warm white color led light strip is off.

Press button 2 again, the green color led light strip is off.

Press button 3 again, the red color led light strip is off.

Press button 4 again, the white color led light strip is off.