Uncategorized

Four-button wireless remote control transmitter (IC PT2262 / SC2262)

There are two types of wireless remote transmitters: electromagnetic waves and infrared. The working distance of the infrared remote transmitter is short, and the infrared ray can only be transmitted through the straight line, and can’t bypass the barrier. RF remote transmitter uses the RF signal, it is transmitted in all directions, and the signal can cross a certain barrier. The electromagnetic wave wireless remote control system uses the transmitter to transmit the electromagnetic wave, and the receiver extracts the electromagnetic wave and triggers various devices. The electromagnetic wave wireless remote control system commonly used in burglar alarm equipment, industrial equipment, doors and windows remote control, car remote control.

The following describes a commonly used four-button wireless remote control transmitter, the parameters are as follows:

Working voltage: DC12V (23A / 12V battery)

Working current: 10mA / 12V

Modulation method: ASK

Frequency: 315MHz / 433MHz

Coding type: fixed code

Working distance: 100 meters

Remote control/transmitter consist of buttons, coding circuit, a modulation circuit, signal amplifier and antenna. The principle of working transmitter: It first generates a specific wireless signal by the key, then the signal pass through the coding circuit, modulation circuit, signal amplifier circuit. Finally, radio waves are emitted through the antenna.

表格插图

原理图PCB图

Four-button wireless remote control transmitter circuit PCB diagram

Four-button wireless remote control transmitter usually uses PT2262 or SC2262 encoding chip.The PT2262 or SC2262 is a low-power encoding chip fabricated in CMOS technology. The PT2262 or SC2262 has up to 12-bit (A0- A11) address-side pins. These pins can be left floating, connect the high level or connect the low level.They can combine up to 531441 sets of codes. The PT2262 or SC2262 has up to six (D0-D5) data-side pins that allow them to combine different data.A complete code consists of address code, data code and synchronization code,this code from pin 17 of PT2262 or SC2262 chip to the data input of the remote control terminal.After the receiving module receives the wireless signal, the decoder chip will compare and verify the signal, and the corresponding data pin of the decoder chip outputs the high-level signal to the amplifying circuit.                                                                                         

The pin diagram of PT2262 or SC2262 is as follows:                                                                              2262引脚图            

Pin Description:

Name Pin Description
A0~A11 1~8、10~13 Address pin, for address coding, can be set to “0”, “1”, “f (dangling)”
D0~D5 7~8、10~13 Data input
Vcc 18 Positive power supply
Vss 9 Negative power supply
TE 14 Coding start-end
OSC1 16 Oscillation resistance input
OSC2 15 Oscillation resistance output
Dout 17 Coded output
manmeds.top | 502: Bad gateway

Error 502 Ray ID: 3f1d3f79d366a627 • 2018-02-23 21:23:44 UTC

Bad gateway

You

Browser

Working
Indianapolis

Cloudflare

Working
manmeds.top

Host

Error

What happened?

The web server reported a bad gateway error.

What can I do?

Please try again in a few minutes.