This rf remote controller (12S1UB-DC06/09/12/24 & CV-12 ) has the special ability to learn remote codes, allowing it to be used in one-transmitter-to-many-receivers system. It operates in toggle, momentary, and latched mode (switch modes as you like freely by connecting or disconnecting jumper). It is great for hard to reach lights or other DC/AC electrical devices, remote distance can be 500m (theoretically). Control lights, motors, fans, electrically operated doors / locks / windows / blinds / cars or other appliances with voltage AC110~240V or DC0~28V.
We’d like to show the wiring and controlling of ac, dc lamps or dc motors.
The contact of relay of each receiver is normally open/ closed. So you need to wire ac lamp to normally open contact B&C and supply AC 220V power to lamp. When you want to remote control dc motors or lamps, you can wire them to receivers as mentioned above. But dc motor and lamps can share the same power supply if you wire as the right picture shown.
Setting control mode Toggle: Connect Jumper-2.
Control mode Toggle: Press -> On; Press again -> Off.
Press button 1: Turn on Receiver 1 (connect B and C, disconnect A and B)
Press button 1 again: Turn off Receiver 1 (disconnect B and C, connect A and B)
…
Press button 12: Turn on Receiver 12 (connect B and C, disconnect A and B)
Press button 12 again: Turn off Receiver 12 (disconnect B and C, connect A and B)
Setting control mode Momentary: Connect Jumper-1.
Control mode Momentary: Press and hold -> On; Release -> Off.
Press and hold button 1: Turn on Receiver 1 (connect B and C, disconnect A and B)
Release button 1: Turn off Receiver 1 (disconnect B and C, connect A and B)
…
Press and hold button 12: Turn on Receiver 12 (connect B and C, disconnect A and B)
Release button 12: Turn off Receiver 12 (disconnect B and C, connect A and B)
Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.
Control mode Latched: Press -> On, other relays Off; Press another button -> Off.
Press button 1: Turn on Receiver 1 (connect B and C, disconnect A and B)
Press other button: Turn off Receiver 1 (disconnect B and C, connect A and B)
…
Press button 12: Turn on Receiver 12 (connect B and C, disconnect A and B)
Press other button: Turn off Receiver 12 (disconnect B and C, connect A and B)
Follow