Motion Triggered Detector and Time Delay Function Receiver Operation

Question from customer:

What we need is three motion sensors with 2 receivers. The receiver can be one channel. Once there is a trigger to any one motion sensor this will trigger both receivers at the same time. Each receiver can have one dry contact output that will trigger anytime any of the motion sensors trigger. And the receiver will go back to previous state after 1 minute.

Answer:

We recommend rf remote receiver and infrared motion sensor (S1DA-DC12-ANT2+W-01) to you. You can have those 2 receivers paired up with three motion sensors so that they can work together. The receiver is delay time adjustable (0 seconds ~ 99 hours). It controls lights, motors, fans, electrically operated doors/locks/ windows/ blinds/ cars or other appliances. You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless signal can pass through walls, floors and doors. With the extended external antenna, its working distance can reach 2000m.

1

The receiver is normally open and close dry contact. So the device which you want to remote control can be supplied with additional power supply according to your device’s voltage parameter. Wire device to normally open dry contact.

1_06

Press buttons of “+” and “-” on the timer, adjust delay time from 0 second to 99 hours. “H” is Hour, “M” is Minute, and “S” is Second. If you want it go back to previous state after 1 minute, you can set “M 0 1”, it means the delay time is 1 minute. When some movements trigger the motion sensor, turn off the relay and turn on device. After 1 minute, it is that the receiver will change status immediately if there is no trigger but will return to previous state after 1 minute. The device is turned off automatically.

Any of the motion sensors can trigger that receiver. If you use those two receivers in the same place, you can set them with different codes.

1000m wireless momentary mode remote control kit with antenna

Question from customer:

I am looking for a radio transmitter receiver 1 channel, 24V, 500 to 1000m, and function: I support the button, close the relay; l loose the button, open the relay.

Answer:

We introduce the wireless remote control kit to you according to your requirement. It is model: S1M-DC24-ANT2 & CB-1. The receiver (S1M-DC24-ANT2) is 1 channel and working voltage is 24V. The transmitter (CB-1) can remote control the receiver within 1000m/3000ft theoretically because of the external extend antenna.

The kit can wireless remote control lights, motors, fans, electrically operated doors/ locks/windows/blinds/cars or other appliances with AC110~240V or DC0~28V. For example, you can connect one light to the receiver. Then you can remote control on/off the light by pressing the buttons on the wireless transmitter. Because the transmitter can launch wireless RF signal to receiver and the signal can pass through walls, floors and doors.

1

The external extend antenna can be mounted to the receiver as following picture: you can connect “ ANT & GND” terminal to the receiver.

1_12  1_03

Here is the circuit diagram of wireless remote control kit. You can connect one lamp to “B & C” terminal of receiver. Then supply power to the receiver. After you press the button, the relay will close and turn on the lamp. So you can turn on/off lamp by wireless remote control.

 1_06

There is one control mode for the wireless remote control kit: momentary. You can operation the kit as following:

When you press and hold the button, turn on the relay

(connect B and C, disconnect A and B).

 

When you release the button, turn off the relay

(disconnect B and C, connect A and B).

 

Finally if you would know more something about the wireless remote control kit, you can enter into our website and search the product as following:

Model: 0020144 (S1M-DC24-ANT2 & CB-1)

 

Website:

http://www.carymart.com/

 

http://www.rfcontrolsystem.com/