12V Motors Run Forward and Reverse through High amp Load Motor Controlling Kit

Overview:

“I want a remote control receiver to control two motors walking a distance of 100 meters without obstacles. The remote control has a receiver to turn two 12V motors. For each motor I want to control forward and reverse.

The operation shall be as follows:

When I press the button, the motor runs. When I release the button, the motor stops. This also applies to the reverse. Please advise me that you?”

Solution:

We recommend high amp load motor controlling kit (S2PF-DC12&CV-6-2) to you. This controller is specially designed for controlling DC motors of rolling blinds / doors, projection screens, awnings, pumps, winches, conveyors or other appliances and mechanicals with voltage DC12V/24V. With two kinds of voltage direct output, it is applied to DC 12/24V electric appliances. Transmitting distance is 500m/1500ft (theoretically).

1_01

Wiring and Operation are fairly easy.

You can connect contact terminals “A1” and “A2” to motor 1; Then you can connect contact terminals “B1” and “B2” to motor 2. Connect contact terminals “+” and “—” to power supply DC 12V or 24V;

1_06

As you described, you can choose “Momentary Mode” for your motors’ operation. Press button, motor runs; release button, motor stops.

Setting control mode Momentary: Only connect Jumper-1 (CN1)

Press and hold button ▲ on the left:  Motor 1 rotates in positive direction

Release button ▲ on the left:  Motor 1 stops

Press and hold button▼ on the left:  Motor 1 rotates in reversal direction

Release button ▼ on the left:  Motor 1 stops

Press and hold button ▲ on the right:  Motor 2 rotates in positive direction

Release button▲ on the right:  Motor 2 stops

Press and hold button▼ on the right:  Motor 2 rotates in reversal direction

Release button ▼ on the right:  Motor 2 stops

Leave a Reply